When it comes to the overhead cranes, dropped loads are the biggest and the most dangerous safety hazards. There are several reasons behind dropped loads. It can be due to poor training of operation; it can be due to the improper technique of rigging that’s being used by the operator, it can be due to the incorrect lifting of the device and it can also occur due to side pulling with the crane. In a nutshell, operating a crane and lifting loads with it isn’t an as easy task and there’s a lot of practice and experience required to do the job properly.
Most importantly, you need to make sure that the lifting hook that you are using is of high quality and is strong enough to carry any load that you have. Speaking of, you should try the Elebia hooks if you really want no trouble lifting up good with your crane because these hooks are just the best in town and well, they are strong enough to carry anything easily, so yes, you should give them a try.
Other than all of this, here are some safety checks that you should perform as an operator before putting your crane into operation. Responsible and established rigging companies know and use all safety protocols and procedures.
1-Test Run
A test run is necessary if you want the crane operation to go all smooth and fine. You should perform the test run full length of the runway and the bridge too, to make sure that there’s no trouble or interference at all in the motion of the crane. Also, make sure that the travel speed of the motion is in accordance with the specifications that have been designed.
2-Turn Off The Crane
Just turn off the crane and then engage the switch of the hoist “up.” When you do this, make sure that the hook of the crane doesn’t rise. Now, check all the other motions to make sure that there’s no movement at all. Once you do that, turn the main switch “on” again and then test the upper limit switch by raising the hook. The hoist and travel motions should be in accordance with the labeled directions.
3-Check The Wire Rope
The wire rope should be properly seated, and it should not have any twists or turns in it. It should not be damaged or kinked too. Just make sure to test all the other devices and the functions before time and then start the operation.
4-New Cranes
If you’ve got new cranes at work, then make sure to train the operators about the new functions and features before time.
These are some of the main safety checks that you must perform before you put your crane into operation. Just use the tips we gave, and we assure you that there won’t be any load dropping or any other such issue that you’ll face during the operation of the crane. We hope this article was useful for you so just follow the instructions for a smooth operation.
